Flyback Converter & Transformer Calculator
The flyback is the most common isolated converter below about 150 W. The turns ratio follows from the maximum duty cycle at minimum input, and the magnetising inductance from the ripple ratio, in CCM or DCM. The calculator then picks a core, turns and air gap with fringing, chooses wire with skin and proximity losses included, sizes the RCD clamp from the leakage energy, and rates the MOSFET for Vin,max plus the clamp voltage.
What you get
- Automatic part selection from a vendor-neutral library: MOSFETs (Si, SiC, GaN), IGBTs and modules, diodes, thyristors, ferrite and powder cores, and capacitors.
- Losses broken down into conduction, switching, gate drive, core, copper and capacitor ESR, with junction temperatures and efficiency at low, nominal and high input.
- Exact switching waveforms, input and output ripple, and harmonic spectra.
- Magnetics design: core, material, turns, air gap, wire or Litz, core loss (iGSE) and winding loss (Dowell).
- Design sweeps, control-loop design with Bode plots, an EMI filter estimate and an exportable bill of materials.
- System chains, for example PFC → LLC → buck, with the efficiency of the whole chain.
- Datasheet PDF import, so you can add and edit your own parts.
How to use it
- Enter your specification in the left panel: input range, output voltage, power and switching frequency.
- Results update instantly. Use the tabs to inspect waveforms, the chosen parts, magnetics and losses.
- Override any automatically chosen part, or import your own from a datasheet.
- Save the design as a file, print it, or export the BOM.
Results are engineering estimates. They use typical datasheet values and first-order switching models, and they do not replace simulation, the manufacturers’ datasheets or prototype testing. The equations used are listed under “Equations & Methods”.